AIRTRONICS MT-4s User's Guide download pdf (Page 56)



T R

Changing the Trim Switch Function:

1) From within the KEY ASSIGN menu, scroll UP or DOWN to highlight TRIM.

2) Press the ENTER key. The TRIM menu will be displayed and TRM1:TRIM-ST will be

highlighted.

3) Scroll UP or DOWN to highlight the function you would like to change for either TRM1,

TRM2, TRM3 or TRM4.

4) Press the ENTER key, then scroll UP or DOWN to choose the desired function for Trim

Switch Trm1, Trm2, Trm3 or Trm4. A list of functions that can be assigned to the Trim

Switches is shown in the table above and on the previous page.

Changing the Trim Switch Step Value:

The Step function allows you to adjust how far the servos travel when the Trim Switches are pressed. You can increase the

Trim Resolution by decreasing the Step value, so that the servos travel less when you press the Trim Switches. This makes it

possible to fine-tune servo movement extremely accurately.

Alternately, you could decrease the Trim Resolution by increasing the Step values, so that the servos travel more when you

press the Trim Switches. This setting may not be as accurate, although it allows you to command large amounts of servo

travel at a time.











ALB-LG

ALB-HL

ALB-RE

OFFSET

AUX1

AUX2

A1CODE1

A1CODE2

A1CODE3

A1CODE4

A1CODE5

A2CODE1

A2CODE2

A2CODE3

A2CODE4

A2CODE5

INC/DEC

MENU FUNCTION DEFAULT SWITCH

DEFAULT REVDEFAULT STEP

Anti-Lock Braking-Lag

Anti-Lock Braking-Hold

Anti-Lock Braking-Release

Throttle Offset

Auxiliary 1 Channel 3

Auxiliary 2 Channel 4

Auxiliary 1 CODE1

Auxiliary 1 CODE2

Auxiliary 1 CODE3

Auxiliary 1 CODE4

Auxiliary 1 CODE5

Auxiliary 2 CODE1

Auxiliary 2 CODE2

Auxiliary 2 CODE3

Auxiliary 2 CODE4

Auxiliary 2 CODE5

Increase/Decrease Values

Rotary Dial

Auxiliary Lever

N/A

------

NOR

N/A

------

1) From within the TRIM menu, scroll UP or DOWN to highlight the Step value you would

like to change for either TRM1, TRM2, TRM3 or TRM4.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Step value for Trim

Switch Trm1, Trm2, Trm3 or Trm4.

TRIM STEP setting range is 1 to 100. The default setting for TRM1 is 5, for TRM2 is 5, for TRM3 is 1 and for TRM4 is 1. The Step

value is a percentage of servo travel.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 87 88

Comments to this Manuals

No comments

AIRTRONICS MT-4s User's Guide Page 56

Comments to this Manuals

Related products and manuals for Remote controls AIRTRONICS MT-4s